龙8-long8(国际)唯一官方网站

300Mbps Speed & NAT High Conversion Rate

TBC-APN2721AB comply with 802.11b/g/n technology to provide up to 300Mbps wireless access speed，and high NAT conversion rate of over 93% to achieve faster download/upload speed, making online surfing faster.

Efficient Energy Saving

Support IEEE802.3az. When there is no addressable frame,the transceiver will enter low power consume mode, and if new frame comes, it will back to active mode instantly. According to the actual flow of the port, adjust energy consumption automatically, and switch fast between full speed & low consume mode,which save 30% power cost.

Beamforming Technology

Beamforming Technology achieves superior Wi-Fi bandwidth utilization and increases Wi-Fi range by creating efficient, highly targeted Wi-Fi connections.

Simple & Efficient Pairing

Need not to be professional nor have a computer, matching the host & subordinative bridge  just by setting the Nixie tube the same number （within 8 points）.

Support 2.4G Full Band

Support 1、2、3、4、5、6、7、8、9、10、11、12、13 band. The special band can be opened if need.

Hardware Configuration
Master Chip	MTK7628KN , 8MB DDR RAM Inside
Flash	1MB
Size	140*75*34mm
Wireless Technology	2.4G（802.11b/g/n）2T2R
Antenna	Inbuilt 13dBi Dual Polarization HG Directional Panel Antenna
Wireless Speed	2.4G 300Mbps
Network Port	1*10/100Mbps RJ45
Power	DC 12V 1A / POE 24V 0.5A
Button	1*Digital Switch, Short Press to Change the Displayed Number 1*Reset，Long Press 5s to Reset 1*Toggle Switch, Dial to Convert Host/Subordinative
Transmission Distance	300m
Operating Frequency	802.11b/g/n:  2.400GHz~2.4835GHz (China)
Output	802.11n: @MCS7:14±2dB,    @MCS0:16±2dB 802.11g: @54M:15±2dB,     @6M:17±2dB 802.11b: @11M:17±2dB,     @1M:19±2dB
EVM	802.11n: ≤-28 DB    802.11g: ≤-25 DB    802.11b: ≤-10 DB
Support Wireless Speed	802.11n: 6.5Mbps and 300Mbps
Work Environment	TEMP：-30℃～+55℃（work），-40℃ ～+70℃（storage） Humidity(Non-Condensing)：10％～90％（work），5％～95％（storage）
Waterproof Rate	IP65
Signal Indicator LED	Bridge Access Point：Output Indicator Under 25%（SIG1 on），25%~50%（SIG1-SIG2 on），50%~75%（SIG1-SIG3 on），75%~100%（SIG1-SIG4 on） Bridge Client：Signal Strength Indicator The light on in turn when connection fails. If connection succeed, 0~-65dBm（SIG1-SIG4 on），-66~-75dBm（SIG1-SIG3 on），-76~-85dBm（SIG1-SIG2 on），under -86dBm（SIG1 on）
LAN1 GigE Indicator	Flicker When Wire Data Transmission , Off When Wire Disconnects
Wireless Indicator	Flickers When Bridge is Running Normally with Power
Power Indicator	With Power, On Without Power, Off

140*75*34mm 

2.4G 300M 500m Digital Bridge.doc